Heat Sinks

Heat sink. The Anomax Corporation Limited, Malthusian, he invented a new heat sink high technology, an innovation called Integrated Plated Circuit Heat Sink (IPCHS ™) that allows much higher results than those achieved so far, and a thermal transfer extremely high. The U.S. patent is being recorded globally. Every day demand increases due to the increase in power required to the components and to meet the needs of the thermal transfer Anomax has invented a heat sink which transfers this through a dielectric.

Alumina & Heatsink

The alumina is the chemical compound that there is more thermally conductive, has a greater power to 30mW against 4mW of thermal pastes of gold, but presents difficulties plating also because of its porosity which traps moisture and ends for do not conduct electricity well. To overcome this drawback the Anomax invented this process that manages to fill the porosity of the metal so as to provide a device perfect dielectric.

Heat Sink: IPCHS

This IPCHS can be provided in two dimensions or in three other complex configurations. He was born of the need to effectively dissipate the heat in all those high-power devices that develop it.

Until now it was possible to produce heat sinks that came to 4 mW thermal management and provided poor performance, with the IPCHS you get to get up to eight times as much and are convinced that the farm will be able to go further. The results obtained prove that the device is capable of cooling the 47% more with the circuits placed directly on the plate of alumina. In addition to these products only the exterior is plated, this saves in their production and to obtain a much more eco-friendly materials and avoiding waste of valuable resources. Has a melting temperature greater than 2000 ° C and then a long life and allows to operate the equipment at the optimum speed rather than slowing them down for heat problems.

The performance of the heat sink IPCHS

The Anomax has demonstrated the process of dissipation in the factory in Penang, Malaysia with excellent performance. The intended application of the IPCHS is very wide, you pass by LED lighting, lasers Blue Ray, inverters and converters, to drivers, to solar and photovoltaic plants, in fact anywhere you need a high-efficiency heat dissipation Thermal. Integrate in the devices is simple and inexpensive. It works fine even if immersed in water and there is the possibility of being able to fabricate the IPCHS according to their circuit design where it is necessary to add it.

How they are produced and tested the IPCHS

Each unit is baked in the oven at 260 ° C for about forty seconds then subjected to drop tests. Is dropped ten times from a height of five feet on a concrete floor. On the plate is made a metallized layer, then a layer of nickel and at last one of gold or copper. The result is the best, high thermal conductivity and strength for your applications. More information can be found on the website that the company has opened them to promote this product: .